lm 22 segelboot

Review of LM 22

Basic specs..

The hull is made of fibreglass. Generally, a hull made of fibreglass requires only a minimum of maintenance during the sailing season. And outside the sailing season, just bottom cleaning and perhaps anti-fouling painting once a year - a few hours of work, that's all.

The boat is equipped with 4 berths.

The LM 22 is equipped with a masthead rig. The advantage of a masthead rig is its simplicity and the fact that a given sail area - compared with a fractional rig - can be carried lower and thus with less heeling moment.

The LM 22 is equipped with a fin keel. The fin keel is the most common keel and provides splendid manoeuvrability. The downside is that it has less directional stability than a long keel.

The keel is made of lead. Compared with iron, lead has the advantage of being 44% heavier, which allows a smaller keel and hence less water resistance and higher speed.

The boat can enter even shallow marinas as the draft is just about 1.30 - 1.40 meter (4.27 - 4.57 ft) dependent on the load. See immersion rate below.

Sailing characteristics

This section covers widely used rules of thumb to describe the sailing characteristics. Please note that even though the calculations are correct, the interpretation of the results might not be valid for extreme boats.

What is Capsize Screening Formula (CSF)?

The capsize screening value for LM 22 is 2.28, indicating that this boat would not be accepted to participate in ocean races.

What is Theoretical Maximum Hull Speed?

The theoretical maximal speed of a displacement boat of this length is 5.7 knots. The term "Theoretical Maximum Hull Speed" is widely used even though a boat can sail faster. The term shall be interpreted as above the theoretical speed a great additional power is necessary for a small gain in speed.

The immersion rate is defined as the weight required to sink the boat a certain level. The immersion rate for LM 22 is about 97 kg/cm, alternatively 544 lbs/inch. Meaning: if you load 97 kg cargo on the boat then it will sink 1 cm. Alternatively, if you load 544 lbs cargo on the boat it will sink 1 inch.

Sailing statistics

This section is statistical comparison with similar boats of the same category. The basis of the following statistical computations is our unique database with more than 26,000 different boat types and 350,000 data points.

What is Motion Comfort Ratio (MCR)?

What is L/B (Length Beam Ratio)?

What is a Ballast Ratio?

What is Displacement Length Ratio?

What is SA/D (Sail Area Displacement ratio)?

What is Relative Speed Performance?

Maintenance

When buying anti-fouling bottom paint, it's nice to know how much to buy. The surface of the wet bottom is about 16m 2 (172 ft 2 ). Based on this, your favourite maritime shop can tell you the quantity you need.

Are your sails worn out? You might find your next sail here: Sails for Sale

If you need to renew parts of your running rig and is not quite sure of the dimensions, you may find the estimates computed below useful.

This section is reserved boat owner's modifications, improvements, etc. Here you might find (or contribute with) inspiration for your boat.

Do you have changes/improvements you would like to share? Upload a photo and describe what you have done.

We are always looking for new photos. If you can contribute with photos for LM 22 it would be a great help.

If you have any comments to the review, improvement suggestions, or the like, feel free to contact us . Criticism helps us to improve.

Great choice! Your favorites are temporarily saved for this session. Sign in to save them permanently, access them on any device, and receive relevant alerts.

• Sailboat Guide

LM 22 is a 21 ′ 11 ″ / 6.7 m monohull sailboat designed by Bent Juul Andersen and built by LM Glasfiber between 1975 and 1981.

Rig and Sails

Auxilary power, accomodations, calculations.

The theoretical maximum speed that a displacement hull can move efficiently through the water is determined by it's waterline length and displacement. It may be unable to reach this speed if the boat is underpowered or heavily loaded, though it may exceed this speed given enough power. Read more.

Classic hull speed formula:

Hull Speed = 1.34 x √LWL

Max Speed/Length ratio = 8.26 ÷ Displacement/Length ratio .311 Hull Speed = Max Speed/Length ratio x √LWL

Sail Area / Displacement Ratio

A measure of the power of the sails relative to the weight of the boat. The higher the number, the higher the performance, but the harder the boat will be to handle. This ratio is a "non-dimensional" value that facilitates comparisons between boats of different types and sizes. Read more.

SA/D = SA ÷ (D ÷ 64) 2/3

• SA : Sail area in square feet, derived by adding the mainsail area to 100% of the foretriangle area (the lateral area above the deck between the mast and the forestay).
• D : Displacement in pounds.

Ballast / Displacement Ratio

A measure of the stability of a boat's hull that suggests how well a monohull will stand up to its sails. The ballast displacement ratio indicates how much of the weight of a boat is placed for maximum stability against capsizing and is an indicator of stiffness and resistance to capsize.

Ballast / Displacement * 100

Displacement / Length Ratio

A measure of the weight of the boat relative to it's length at the waterline. The higher a boat’s D/L ratio, the more easily it will carry a load and the more comfortable its motion will be. The lower a boat's ratio is, the less power it takes to drive the boat to its nominal hull speed or beyond. Read more.

D/L = (D ÷ 2240) ÷ (0.01 x LWL)³

• D: Displacement of the boat in pounds.
• LWL: Waterline length in feet

Comfort Ratio

This ratio assess how quickly and abruptly a boat’s hull reacts to waves in a significant seaway, these being the elements of a boat’s motion most likely to cause seasickness. Read more.

Comfort ratio = D ÷ (.65 x (.7 LWL + .3 LOA) x Beam 1.33 )

• D: Displacement of the boat in pounds
• LOA: Length overall in feet
• Beam: Width of boat at the widest point in feet

Capsize Screening Formula

This formula attempts to indicate whether a given boat might be too wide and light to readily right itself after being overturned in extreme conditions. Read more.

CSV = Beam ÷ ³√(D / 64)

Embed this page on your own website by copying and pasting this code.

• About Sailboat Guide

©2024 Sea Time Tech, LLC

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

• Mijn profiel
• Recente discussies
• Varen met...
• Reisverhalen
• Weergrafieken
• Forumregels
• Wie zijn wij

Welkom  

• Gebruikersnaam/wachtwoord verloren?

Mijn Menu  

• ZeilersWiki

What's Up  

Wedstrijd  

Onderwerp: Ervaringen met een LM 22

Ervaringen met een lm 22 10 aug 2018 09:59 #967301.

Ervaringen met een LM 22 23 sept 2018 17:24 #981386

Ervaringen met een LM 22 23 sept 2018 18:20 #981404

Ervaringen met een lm 22 23 sept 2018 18:43 #981421, ervaringen met een lm 22 24 sept 2018 08:48 #981576.

Ervaringen met een LM 22 24 sept 2018 09:04 #981583

Ervaringen met een LM 22 24 sept 2018 11:08 #981635

Ervaringen met een LM 22 24 sept 2018 11:15 #981638

Ervaringen met een LM 22 27 dec 2018 10:27 #1008462

Ervaringen met een LM 22 27 dec 2018 10:59 #1008469

The Lm 22 is a 21.98ft masthead sloop designed by Bent Juul Andersen and built in fiberglass by LM Glasfiber (DEN) between 1975 and 1981.

240 units have been built..

The Lm 22 is a moderate weight sailboat which is slightly under powered. It is very stable / stiff and has a low righting capability if capsized. It is best suited as a day-boat.

Lm 22 for sale elsewhere on the web:

Main features

Login or register to personnalize this screen.

You will be able to pin external links of your choice.

See how Sailboatlab works in video

We help you build your own hydraulic steering system - Lecomble & Schmitt

Accommodations

Builder data

Modal Title

The content of your modal.

Personalize your sailboat data sheet

Paste a link here:

Give it a title:

And eventually a link to an image for the thumbnail: